.Flame    ATmaP    Static Control    Plasma    Corona    Robotics            Surface Treatment Engineers 

 

Home
Up

Contact Information:

Tel:  +44 (0) 1543 411460
Fax: +44 (0) 1543 415140
Post: Dyne Technology Ltd
         Newton House
         5 Parkside Court,
         Greenhough Road
         Lichfield
         Staffordshire,
         WS13 7FE
         United Kingdom.
 
E-mail   
info@dynetechnology.co.uk
 
Web Site:
www.dynetechnology.co.uk

 

CORONA TREATMENT: LABEL TREATER                                                              

        

The purpose of surface corona treatment of polymer-based materials is to increase surface wettability through electrical discharge. The low surface energy of polymer-based substrates often leads to poor adhesion of inks, glues and coatings. To obtain optimum adhesion, it is necessary to increase the surface energy of the substrate to just above that of the material to be applied. Surface Treatment with Corona results in good wetting of the material over the surface of the substrate and so improves adhesion. For Corona Treatment of Narrow Web, Dyne Technology offers:

LabelTec, designed for the pre-treatment of conductive and non-conductive narrow webs. This type of corona treating system will treat either one or both sides of the web and will accommodate widths from 100-500mm, running at production speeds of up to 150m/min.

For a wide range of Silicone Sleeves << Click here>>

 >> Dyne Home Page

Contact Information:

Phone:    +44 (0) 1543 411460
Fax:        +44 (0) 1543 415140
Post:        Dyne Technology Ltd, Newton House, 5 Parkside Court, Greenhough Road, Lichfield, Staffordshire, WS13 7FE, United Kingdom.
E-mail     info@dynetechnology.co.uk

[Home] [Up]

Copyright 2005 - 2010 Dyne Technology Ltd - All rights reserved.   -   Web Site Design by 2 Stars   -   Last modified: 09/03/10